﻿ The lower edge of a square slab of side 50 cm and thickness 20 cm is rigidly fixed to the base of a table. A tangential force of 30 N is applied to the slab. If the shear moduli of the material is 4 x 1010 N/m2, then displacement of the upper edge, in meters is | Mechanical Properties of Solids

Previous Year Papers

Download Solved Question Papers Free for Offline Practice and view Solutions Online.

Test Series

Take Zigya Full and Sectional Test Series. Time it out for real assessment and get your results instantly.

Test Yourself

Practice and master your preparation for a specific topic or chapter. Check you scores at the end of the test.

Mechanical Properties of Solids

Multiple Choice Questions

11.

One solid sphere A and another hollow sphere B are of same mass and same outer radii. Their moment of inertia about their diameters are respectively IA and IB such that

Where dA and dB are their densities.

• IA = IB

• IA > IB

• IA < IB

• IA < IB

415 Views

12.

What would be the work done in stretching a wire.

143 Views

13.

A granite rod of 60 cm length is clamped at its middle point and is set into longitudinal vibrations. The density of granite is 2.7 x 103 kg/mand its Young’s modulus is 9.27 x 1010 Pa. What will be the fundamental frequency of the longitudinal vibrations?

• 7.5 kHz

• 5 kHz

• 2.5 kHz

• 10 kHz

14.

The density of a material in the shape of a cube is determined by measuring three sides of the cube and its mass. If the relative errors in measuring the mass and length are respectively 1.5% and 1%, the maximum error in determining the density is:

• 6%

• 2.5%

• 3.5%

• 4.5%

15.

A solid sphere of radius r made of a soft material of bulk modulus K is surrounded by a liquid in a cylindrical container. A massless piston of the area a floats on the surface of the liquid, covering an entire cross section of cylindrical container. When a mass m is placed on the surface of the piston to compress the liquid, the fractional decrement in the radius of the sphere, (dr/r), is

• mg/Ka

• Ka/mg

• Ka/3mg

• mg/3Ka

16.

Which of the following statement related to stress-strain relation is correct ?

• Stress is linearly proportional to strain irrespective of the magnitude of the strain

• Stress is linearly proportional to strain above

• Stress is linearly proportional to strain for stress much smaller than at the yield point

• Stress-strain curve is same for all materials

17.The lower edge of a square slab of side 50 cm and thickness 20 cm is rigidly fixed to the base of a table. A tangential force of 30 N is applied to the slab. If the shear moduli of the material is 4 x 1010 N/m2, then displacement of the upper edge, in meters is4 × 10-12 4 × 10-10 6 × 10-10 6 × 10-12

C.

6 × 10-10

18.

Two wires A and B of same material and of equal length with the radii in the ratio 1 : 2 are subjected to identical loads. If the lengthof A increases by 8 mm, then the  increase in length of B is

• 2 mm

• 4 mm

• 8 mm

• 16 mm

19.

A ball falling in a lake of depth 400 m has a decrease of 0.2% in its volume at the bottom. The bulk modulus of the material of the ball is (in Nm-2)

• 9.8 × 109

• 9.8 × 1010

• 1.96 × 109

• 9.8 × 1011

20.

A steel plate of size 6 cm x 6 cm is to be coated by a metal on both sides with a coating thickness of 0.1 mm by electrolysis. If the density and ece of the metal are respectively 10 g cm-3 and 0.001 gC-1 then the strength of the current to complete the process in one hour is

• 1 A

• 0.5 A

• 6 A

• 2 A